Subaru L101SFL000 Instructions De Montage page 18

14 WIRING HARNESS INSTALLATION (CONT'D)
Route the connector at the opposite end through the hole in the rear panel and into the
15
trunk area.
16 Install the rubber grommet into the hole.
Secure the wirining harness to the hitch member tube with (3) 11" cable ties "O" as
17
shown.
Attach the [RAB] connector to the hitch bracket using the piece of hook & loop "R".
18
Remove the adhesive liner and stick one side to the connector and the other to the
bracket.
19 Secure the connector to the bracket using an 11" cable tie "O" by wrapping the cable
tie through the [RAB] connector and around the bracket.
PART NUMBER ISSUE
L101SFL000 1
150m
17
18
[RAB]
DATE
6/26/2017
15
16
150m
17
19
SUBARU OF AMERICA
PAGE
16
OF 18