Post Installation Checklist - Subaru H001SXC300 Instructions D'installation

11

POST INSTALLATION CHECKLIST

1. REMOTE ENGINE START- Make sure the key is removed from the ignition switch, the engine hood, all
doors and trunk are closed. Press the START button on the remote start transmitter two (2) times within
three (3) seconds. The vehicle’s parking lights should  ash and the vehicle’s horn should honk one (1) time
and then the vehicle should crank and start. Once started, the transmitter LED will  ash two (2) times and
the parking lights will turn on and stay on signifying the vehicle is running. The transmitter LED will  ash
one (1) time every three (3) seconds signifying the vehicle is still running.
NOTE: If the vehicle does NOT respond to the remote start transmitters, proceed to SECTION 12 for
the TRANSMITTER PROGRAMMING procedure.
2. SHUT DOWN WITH DOOR OPENING - While the vehicle is running by the remote engine start, wait at least
 ve (5) seconds and then con rm that all functions (lock, unlock & trunk, but not panic) operate properly on
the FACTORY transmitter. Once the FACTORY transmitter functionality is con rmed, press the UNLOCK
button on the FACTORY transmitter and open any vehicle door. The remote engine start should shut down
and the transmitter LED should  ash three (3) times indicating the system has shut down.
3. ACTIVATION WITH DOOR OPEN - Ensure the key is removed from the ignition switch and the engine hood
and trunk are closed. Open the driver’s door, press the START button on the remote start transmitter two
(2) times within three (3) seconds. The vehicle’s parking lights should  ash and the vehicle’s horn should
honk six (6) times. The vehicle should not start with any door or trunk opened.
4. BRAKE PEDAL SAFETY - While sitting in the vehicle with the engine hood, all doors and trunk closed,
activate the remote engine start and press the brake pedal. The vehicle should shut o .
5. KEY-IN-SENSE - While sitting in the vehicle with the engine hood, all doors and trunk closed, insert the
ignition key into the ignition switch, but keep it in the OFF position. Activate the remote engine start. The
vehicle’s parking lights should  ash and the vehicle’s horn should honk two (2) times. The vehicle should
not start since the key is in the ignition switch. Remove the ignition key from the ignition switch.
6. HOOD SAFETY SWITCH - Open the engine hood and activate the remote engine start. The vehicle’s parking
lights should  ash and the vehicle’s horn should honk two (2) times. The vehicle should not start since the
hood safety switch is activated.
7. HEATER / A/C FUNCTION - Using the ignition key, turn the ignition to the ON position. Preset the vehicle’s
heater or air conditioning to the ON position. Turn the ignition OFF and remove the ignition key. Activate
the remote engine start and verify that the heater or air conditioning turns on to the preset setting for manual
climate controlled vehicles or turns to the “Full Auto” setting for electronic climate control vehicles.
8. 15 MINUTE RUN TIME - Activate the remote engine start and allow the system to run for the 15 minute
preset run time. The remote engine start should shut down after 15 minutes (+/- 10 seconds).
9. TRANSMITTER FUNCTIONALITY VERIFICATION - Activate the remote engine start using both of the
supplied single button remote start transmitters.
FUNCTIONAL TESTING IS NOW COMPLETE.
PART NUMBER ISSUE
H001SXC300
DATE
- 24 May 2022
SUBARU OF AMERICA
13 OF 14