Post Installation Checklist - Subaru H001SVC000 Manuel D'installation

12

POST INSTALLATION CHECKLIST

1. REMOTE ENGINE START- Ensure the Access key is removed from the vehicle, the engine hood, all doors
and trunk are closed. Press the START button on the remote start transmitter two (2) times within three
(3) seconds. The vehicle's parking lights should fl ash and the vehicle's horn should honk one (1) time and
then the vehicle should crank and start. Once started, the transmitter LED will fl ash two (2) times and the
parking lights will turn on and stay on signifying the vehicle is running. The transmitter LED will fl ash one
(1) time every three (3) seconds signifying the vehicle is still running.
NOTE: If the vehicle does NOT respond to the remote start transmitters, proceed to SECTION 13 for
the TRANSMITTER PROGRAMMING procedure.
2. CUSTOMER TAKE OVER - While the vehicle is running by the remote engine start, wait at least fi ve (5)
seconds and then confi rm that all functions (lock, unlock & trunk, but not panic) operate properly on the
Access key (FACTORY transmitter). Once the Access key functionality is confi rmed, press the UNLOCK
button on the Access key, open the driver's door and enter the vehicle with the Access key. Press and hold
the brake pedal, press the ENGINE START/STOP button on the dashboard one (1) time and move the shift
position lever from the "P" position to the "D" position and back to the "P" position. The remote engine start
should shut down and the transmitter LED should fl ash three (3) times indicating the system has shut down,
but the engine should remain running. Press the ENGINE START/STOP button on the dashboard one (1)
time to turn off the vehicle.
3. ACTIVATION WITH DOOR UNLOCKED - Ensure the Access key is removed from the vehicle, the engine
hood, all doors and trunk are closed and the driver's door is unlocked. Press the START button on the
remote start transmitter two (2) times within three (3) seconds. The vehicle's parking lights should fl ash and
the vehicle's horn should honk six (6) times. The vehicle should not start with the driver's door unlocked.
4. ACTIVATION WITH DOOR OPEN - Ensure the Access key is removed from the vehicle and the engine hood
and trunk are closed. Open the driver's door and press the START button on the remote start transmitter two
(2) times within three (3) seconds. The vehicle's parking lights should fl ash and the vehicle's horn should
honk six (6) times. The vehicle should not start with any door or trunk opened.
5. HOOD SAFETY SWITCH - Open the engine hood and activate the remote engine start. The vehicle's parking
lights should fl ash and the vehicle's horn should honk two (2) times. The vehicle should not start when the
hood safety switch is activated.
6. HEATER / AC FUNCTION - With the Access key inside the vehicle, press the ENGINE START/STOP button
on the dashboard two (2) times to turn ON the ignition. Preset the vehicle's heater or air conditioning to
the ON position. Press the ENGINE START/STOP button on the dashboard one (1) time to turn OFF the
ignition and remove the Access key from the vehicle. Activate the remote engine start and verify that the
heater or air conditioning turns on to the preset setting for manual climate controlled vehicles or turns to the
"Full Auto" setting for electronic climate control vehicles.
7. 15 MINUTE RUN TIME - Activate the remote engine start and allow the system to run for the 15 minute
preset run time. The remote engine start should shut down after 15 minutes (+/- 10 seconds).
8. TRANSMITTER FUNCTIONALITY VERIFICATION - Activate the remote engine start using both of the
supplied single button remote start transmitters.
FUNCTIONAL TESTING IS NOW COMPLETE.
PART NUMBER ISSUE
H001SVC000/200
DATE
- 27 Aug 2021
SUBARU OF AMERICA
9 OF 10