Preparation - Before Installation - Subaru E771SCA700 Instructions D'installation

PREPARATION - BEFORE INSTALLATION:

1. APPLICATION SOLUTION: Fill 32oz. trigger type spray bottle
with 20% Alcohol 80% Water add 5 to 7 drops (1ml) of Dish
Soap. Note: Solution depends on temperature of part,
temperature of vehicle surface and other factors. Note: more
soap makes it easier for the squeegee to slide bubbles out
from under the part when installing.
2. This product should be installed with proper installation tools.
3. Install this product while observing all warnings and precautions
stated in this instruction booklet.
4. VERY IMPORTANT: Thoroughly wash vehicle with Soap and
Water.
5. Parts storage should be flat at room temperature and in a clean
dry place. Care should be taken to avoid a dusty environment.
* Rear Bumper Protection Film in Place
1 Inspect Bumper Surface
Inspect painted bumper surface for contaminates. Clean or
buff surface if required.
Bumper Applique
SIDE VIEW
Notch in
Bumper.
Notch in
Applique
Locate notches in applique
to notches in bumper.
3 Dry Fit
Before removing liner, locate the two notches in the applique
directly under the notches in bumper and align as shown above.
DESCRIPTION
Rear Bumper Protection Film
Work from directly above for best
alignment of part to front edge
Bumper Applique
Align front
edge here
Rear Bumper
ISSUE
00
Notes to the Installer
1. Read the entire installation pamphlet prior to beginning the
installation of the accessory.
2. Ensure that the vehicle is properly protected in the area that
the accessory is to be installed.
3. To prevent vehicle damage, never place tools on top of painted
surfaces, seats, dash pad, console or floor carpet / mat.
4. Always wear appropriate safety gear to include gloves and eye
protection when required.
2
Alcohol
Thoroughly wash vehicle with a soft lint-free cloth. Wipe rear
bumper area where applique will be placed,using alcohol or
Separate cloth sprayed with alcohol (70% isopropyl). Allow
the area to dry completely.
**Use tabs when handling applique so no finger prints are left on the
part adhesive.
4
Spray Bumper Surface
Spray bumper surface with Application Solution.
DATE
SUBARU OF AMERICA
02/22/12
PAGE
2/08