Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Remote electronics kit option (REK 1)
This is a hardware kit to allow the electronics panel to be located up to 30 m (90') away from the loudspeaker
cabinet. The benefits enjoyed when loudspeakers are flush mounted are: lack of heat dissipation problems, easy
adjustment of the controls, and easier electronics servicing. An 8-pole Speakon terminated cable carries the
driver signals and a CAT-5 cable carries the display signals. Additional space is not required behind the cabinet as
the connectors face downwards when installed. The connections are as follows (note: "Bass 2" is not used when
there is only one bass driver in the cabinet):
Drivers
Bass 1
Bass 2
Midrange
Treble
The cabinet's serial number is printed under the bass ring – pull it gently by hand to remove it – so it is visible
when the cabinet is flush mounted. This number should be matched to the serial number printed on the remote
located electronics panel.
Cable pack (CP nn)
A CAT-5 and 8-core driver cable of length 2, 5, 10, 15, 20, 25, and 30 m (6', 15', 30', 45', 60', 75', and 90') are
available from Klein + Hummel (Cable Pack 2, 5, 10, 15, 20, 25, or 30), or industry standard cables may be
sourced from a third party. The Klein + Hummel cables use flame retardant materials and high-quality metal
connectors (Neutrik EtherCon NE8MC and Neutrik Speakon NLT8FX). The conductor specification is shown in the
table below:
Operating Manual O 410
Speakon Pins
Display
1 -/+
K+H Logo -/+
2 -/+
Red -/+
3 -/+
Yellow -/+
4 -/+
Green -/+
Length
<=20 m (60')
2.5 mm
>20 m (60')
English
RJ-45 Pins
1 & 2
3 & 8
4 & 7
5 & 6
Wire Gauge
2
(14 AWG)
2
4 mm
(12 AWG)
Klein + Hummel
16
Publicité
Table des Matières
