C.2 Voltage / Resistance Or Temperature Simulation - AOIP TC6621 Mode D'emploi

TC-TM 66XX
C.2 Voltage / resistance or temperature simulation
To access the Emission mode:

The choice of Emission mode is made using the F2 key (mode menu).
Using the navigation keys ( and ), position the cursor in the Emission field going down the menu.


Confirm your choice using the VAL key.
Once you have confirmed the Emission mode, define the type of generation:

Continuous (manual or arrows or default editing).
 Incremental (by step or "manual default").

By single ramp (only one ramp emitted).

By cyclic ramp.
 Synthesizer ("automatic default").
 Voltage / resistance or temperature generation / manual editing?

Press the F2 key to display the edit menu.
Using the navigation keys ( and ), choose the Manual edit mode and confirm (VAL key).


Press VAL again and enter your value using the navigation keys:
 and  to increase or decrease the value
o
o  and  to select the digit to modify (hundreds/tens/unit/decimal place/hundreds).
Beware: if the Scaling mode is ON, the value to edit is expressed in the unit defined, otherwise this value is expressed in
Volts or in °C or °F.
70 / 101 NTA47230-300A6
PROGRAMMING MODES