Programming Mode; C.1 Voltage / Resistance Or Temperature Measurement - AOIP TC6621 Mode D'emploi

TC-TM 66XX
C. PROGRAMMING MODES
C.1 Voltage / resistance or temperature measurement

The choice of measurement or emission mode is made using the F2 key (mode menu).
Using the navigation keys ( and ), position the cursor in the Measurement field going down the menu.


Confirm your choice using the VAL key.
Note that the Measurement mode is the mode selected by default.

The function type selection (Thermocouple or resistive sensor type) is made using the F1 key (Configuration
menu).
Using the navigation keys ( and ), position the cursor in the Function field.


Confirm the latter using the VAL key.
In the CONFIGURATION MESURE (MEASUREMENT CONFIGURATION) menu, position the cursor in the Couple or
Sonde field using the F1 key.

Enter the Couple or Sonde menu using the F2 key.
Choose the type of thermocouple (K, T, J...), using the navigation keys ( and ) or the type of resistive sensor

(PT50, PT100, PT200...).

Press VAL to confirm.

Using the F1 key, define the Unit by positioning the cursor on it.

Enter the menu by pressing F2.
Using the navigation keys ( and ), choose the unit.


Press VAL to confirm.
68 / 101 NTA47230-300A6
PROGRAMMING MODES