AOIP TC6621 Mode D'emploi page 71

 Voltage / resistance or temperature generation / arrow editing?

Press the F2 key to display the edit menu.
Using the navigation keys ( and ), choose the Arrows edit mode and confirm (VAL key).


Use the navigation keys to enter the value:
 and  to increase or decrease the value
o
 and  to select the digit to modify (hundreds/tens/unit/decimal place/hundreds).
o
Indicates that the
mode used is the
arrows mode
Digit
during editing
 Voltage / resistance or temperature generation / incremental editing?

Press the F2 key to display the edit menu.
Using the navigation keys ( and ), choose the INCREASES mode and confirm (VAL key).

The values emitted are those defined in the CONFIGURATION/RAMP menu (see the chapter entitled Related functions).

Using the navigation key (), start the automatic increases phase (following the parameters programmed in the
CONFIGURATION/RAMP menu).

Using the navigation key (), you can decrease automatically starting from the max. programmed voltage (or
temperature).

Using the navigation key (), you can increase manually the voltage (or temperature) emitted (following the
parameters programmed in the CONFIGURATION/RAMP menu).

Using the navigation key (), you can decrease manually the voltage (or temperature) emitted starting from the
max. programmed voltage.
 Voltage / resistance or temperature generation / single ramp editing?

Press the F2 key to display the edit menu.
Using the navigation keys ( and ), choose the SINGLE RAMP mode and confirm (VAL key).

The values emitted are those programmed in the CONFIGURATION/RAMP menu (see the chapter entitled Related
functions).

Using the navigation key (), start the automatic increases phase (following the parameters programmed in the
CONFIGURATION/RAMP menu).

Using the navigation key (), you can decrease automatically starting from the max. programmed voltage (or
temperature).

Using the navigation key (), you can increase manually the voltage (or temperature) emitted (following the
parameters programmed in the CONFIGURATION/RAMP menu).

Using the navigation key (), you can decrease manually the voltage emitted starting from the max. programmed
voltage (or temperature).
The Hold key allows you to stop generating or to resume it
You can resume the generation of the ramp in step-by-step mode by pressing the navigation keys ( and ) or in
automatic generation using the navigation keys ( and ).
You can delay the emission by a programmable amount of time (in the CONFIGURATION/RAMP/DELAY menu)
Voltage / resistance or temperature simulation
selected
C
NTA47230-300A6 71 / 101