Changing The User Code - Arregui AWA Mode D'emploi

2. OPENING AND CLOSING THE SAFE VIA THE
KEYPAD
2.1. OPENING
• Press the , button and the keypad will light up.
• Wait around 5 seconds (the knob will light up in blue).
• Enter one of the authorised user codes (or the default code
1234567, if the safe hasn't been set up yet), then press the
button to confirm.
• If the code is correct, the knob will light up in green and
beep for two seconds, and during this time you will be able
to open the safe by manually turning the knob (90 degrees
clockwise).
2.2. CLOSING
• Turn the knob 90 degrees anti-clockwise. You will hear 3
consecutive beeps, indicating that the safe has been closed
correctly.
NOTA: if you enter the wrong code, the knob will light up in red
and emit 3 short beeps.
3. CHANGING THE CODES
3.1. CHANGING THE ADMINISTRATOR CODE
The default Administrator code for the safe will be 1234567.
Change via APP:
To change the administrator code, follow the procedure des-
cribed in point 1.3.d. "User modification".
Change by KEYBOARD:
• Open the safe by following the steps described in section:
2.1. Operating the safe with the keypad.
• Once it is open, press the
light up.
• Complete the following sequence:
<PREVIOUS_PASSWORD>
<NEW PASSWORD>
If the process has been saved correctly, the knob will light up
in green. If not, it will light up in red for a few seconds.

3.2. CHANGING THE USER CODE

The user codes can only be amended through the mobile app
using the Administrator's credentials.
See point "1.3.d. Modifying users" for changing any user
codes, including the Administrator's code (ADMIN).
button and the keypad will
<NEW PASSWORD>
4. EMERGENCY OPENING
An envelope containing an emergency key will be supplied
along with these instructions.
If you lose or misplace the codes, or if there is some kind of
problem with the safe (the batteries run out, etc.), you can
open it using the emergency key.
You can do this as follows:
• Insert the emergency key into the lock.
• Turn the emergency key 10 degrees clockwise, until you
feel it stop against the inner latch.
• Turn the knob 90 degrees clockwise.
• Open the safe.
NOTE: You will receive a mechanical fault alert if you don't
follow the previous steps correctly.
5. USING THE EXTERNAL POWER SUPPLY
If the rechargeable battery has run out of power, which you
will know if the knob does not turn on within 20 seconds after
being pushed, and you do not have the emergency key, you can
power the safe using the USB cable provided by Arregui.
All you need to do is plug in the USB cable to the outlet on the
lower part of the knob, and connect the other end of the cable
to a power supply (a laptop or another similar device, a plug
connected to the power supply with a USB adaptor, etc.).
40
En
Emergency lock
Remove cover
to access lock