General Instructions; Very Important - Arregui AWA Mode D'emploi

COMPONENTS INCLUDED WITH THE AWA
SMARTSAFE SYSTEM
• AWA SAFEBOX
• Emergency key
• Knob
• Outlet for battery charger
• 3.7 V battery (included)
• USB cable
• Interior LED
• Keypad

GENERAL INSTRUCTIONS

It is important to read these instructions carefully before
using the AWA safe for the rst time, and to keep them
safe for any future queries.
• THE BATTERY:
- The AWA safe has a self-sufficient rechargeable battery that
will remain charged for approximately 2 months.
- The battery should be recharged as soon as it is installed (4
hours for a full charge) and then charged again whenever it
runs out, using the USB cable that is provided with the safe.
You will be able to see the remaining battery power on the
main menu of the mobile app once it has been validated in
the system.
- The safe box has an automatic internal control system that
allows the user to check if the battery is low (around 20%).
If it is, the registered cloud user will receive an email and a
push notification informing them of said circumstance. The
remaining battery information will also be shown on the app's
main menu.
- The AWA safe has been designed so that the battery uses as
little energy as possible, so we therefore advise that, if the
knob is still lit after you close the safe, you press it again
to put the circuit into idle mode (you will know this has been
done as the light on the knob will turn off). This will allow the
self-sufficient battery to last longer.
• In order to use all of the safe's features from your smartphone,
see point "1.1. Registration and initialization of the safe".
• To find out how to open the safe with the mobile app after
setting it up for the first time, see point "1.2. Opening and
closing the safe".
• The settings for your safe can only be changed through
the mobile app, and you can find out how on point "1.3.
Configuring the system".
• For remote access functions, which are only available for the
safe box administrator, see point "1.4. Remote management".
• It is recommended to change the default Administrator code
that is supplied with the safe. To find out how to change the
codes, see point "3. Changing the codes".
• If the batteries run out, or there is any other issue, the safe
has an emergency key and an external power supply that
can be connected by USB. For more information, see points
"4. Emergency opening" and "5. Using the external power
supply".
• The serial number for the safe is located on the front of the
door and on the front cover of these instructions. You will need
this number for requesting emergency openings, spare parts,
etc.
TERMINOLOGY
ARREGUI AWA ACCOUNT: Account that is registered in the
Cloud server and that is essential to register / associate each
of the Arregui devices with which you want to operate through
the app.
OWNER: The person who registers the safe and registers as a
holder in the Arregui AWA account.
ADMINISTRATOR CODE: Code that allows you to open the
safe and carry out procedures at higher levels than those
allowed for user codes.
ADMINISTRATOR: Person who owns the administrator code.
USER CODE: Code that only allows the opening of the safe.
USER: Person who owns the user code.

VERY IMPORTANT

Opening the safe box for the first time:
If your safe box is closed when it arrives, you can open it using
the emergency key.
• Insert the emergency key into the lock.
• Turn the emergency key 10 degrees clockwise, until you
feel it stop against the inner latch.
• Turn the knob 90 degrees clockwise.
• Open the safe.
32
En
Emergency lock
Remove cover
to access lock