Changing Master Code - Arregui TITAN 12000-S1 Mode D'emploi

<EN>
B.3.1 CHANGING MASTER CODE
• Press the key 0 and keep it pressed until you hear a double beep.
• Enter the initial master code 123456.
• Enter the new master code (6 digits minimum and 12 digits maximum). 2 beep sound.
• Repeat the new master code. If the new code is entered correctly, 2 beep sound. Otherwise, a long beep
sounds warning that the operation was not successful, so the initial code remains saved. Repeat again the
operation.
B.3.2 PROGRAMMING USER CODE
• Press the key 1and keep it pressed until you hear a double beep.
• Enter the valid master-code (1-2-3-4-5-6 if original one has not been changed in advance).
• Enter the user code (6digits minimum and 12 digits maximum) 2 beep sound.
• Repeat the user code. If the new code is entered correctly, 2 beep sound. Otherwise, a long beep sounds
warning that the operation was not successful. Repeat again the operation.
• Whenever, at the beginning of the operation, when you enter the main code, the safe sends out a long beep,
it will indicate that a user code has been previously set out. In this case, see the point B.3.3 to modify the
user code.
B.3.3 CHANGING USER CODE
The change of the user code without using the master code is possible only if the user code was set in
advance by using the master code.
• Press the key 0 and keep it pressed until you hear a double beep.
• Enter the valid user code.
• Enter the new user code (6digits minimum and 12 digits maximum) 2 beep sound.
• Repeat the new user code. If the new code is entered correctly, 2 beep sound. Otherwise, a long beep sounds
warning that the operation was not successful, so the initial code remains saved. Repeat again the operation.
B.3.4 DELETING USER CODE
• Press the key 3 and keep it pressed until you hear a double beep.
• Enter the valid master-code.
• The user code is deleted. You can set it out again by following the steps of the point B.3.2.
• In the case the safe sends out a double beep and a long beep, no user code has been activated.
B.4. SETTING OUT THE OPENING DELAY.
This safe allows setting out an opening delay up to 99 minutes, as well as the time you wish the system to
remain opened (opening slot) up to 19 minutes.
• Press the key 9 and keep it pressed until you hear a double beep.