Brick Panel Installation; Glass Media - Napoleon WHD31N Instructions D'installation Et D'opération

5.4

BRICK PANEL INSTALLATION

Carefully remove the 4 screws securing the brick retainer.
A.
Uninstall the brick panels and remove the packaging.
B.
Center the rear brick panel against the back of the fi rebox with the bottom edge resting on the back
C.
fl ange.
Place the top brick panel against the top of the rear brick panel. Align the holes in the brick retainer
D.
with the holes in the fi rebox and secure using the 4 screws provided.
5.3

GLASS MEDIA

CLEAN THE GLASS MEDIA PRIOR TO INSTALLATION. BEFORE APPLYING THE CLEANED GLASS, ENSURE
DO NOT CHANGE OR SUBSTITUTE THE GLASS MEDIA MATERIAL PROVIDED WITH THIS APPLIANCE. IF
REPLACING, USE ONLY THE REPLACEMENT GLASS MEDIA AVAILABLE FROM YOUR AUTHORIZED
GLASS MEDIA OVER THE BURNER MUST NOT BE MORE THAN ONE LAYER HIGH. MORE THAN ONE LAYER
OVER THE BURNER WILL CAUSE FLAME LIFTING AND SOOTING PROBLEMS.
Evenly spread the glass media onto the media tray, covering the burner tube and tray.
Do not cover burner ports with glass media. Glass media over the burner ports may cause a "Puffi ng" sound.
To eliminate this sound, simply push the media away from the burner ports.
NOTE: The distribution of glass media over the burner ports will infl uence the fl ame height. When the
fl ames impinge on the glass, the glass may discolour slightly and the edges may soften.
CLEANING GLASS MEDIA
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
WARNING
!
THAT IT IS DRY.
DEALER / DISTRIBUTOR.
29
74.1B
W415-1337 / 06.23.14
EN