Horizontal Installation - Napoleon WHD31N Instructions D'installation Et D'opération

4.2

HORIZONTAL INSTALLATION

Level and affi x the mounting template to
A.
the wall at the desired location and height.
The centre of the vent pipe must be located
between wall studs.
Using the template, mark the holes for the
B.
vent, gas and electrical outlets, and mounting
screws. See "MINIMUM CLEARANCES TO
COMBUSTIBLES" section. Note: There are
two sets of four mounting screws, choose
the appropriate set for either 16" (406mm)
or 24" (610mm) studs.
Remove the mounting template from the wall
C.
and cut the holes as marked.
Remove the 4 screws that secure the wall
D.
mounting plate to the appliance.
If fl exible venting is to be used, remove the
E.
rigid fi restop spacer.
The shield and defl ector have been designed
F.
to accommodate a maximum wall depth of
12" (305mm). Determine the depth of the wall
and cut the shield and defl ector accordingly.
The shield must extend the full depth of the
combustible wall.
Screw the shield together using the screws
G.
provided.
Secure the ring to the fi restop plate on the
H.
back of the mounting plate using the 4
screws provided.
Bend the 6 tabs on the defl ector as
I.
shown.
Slide the
J.
shield onto
the ring and
align the
holes. Using
6 of the
screws provided, secure the shield to
the ring.
Attach the defl ector above the shield
K.
assembly using 5 of the screws provided.
Apply a bead of caulking (not supplied) to the fl ange. Insert the shield assembly into the wall, level the
L.
mounting plate and secure it using 4 fasteners. The fasteners must be mounted to the wall studs.
RIGID
FIRESTOP
SPACER
GAS
OUTLET
MOUNTING PLATE
CAULKING
FLANGE
DEFLECTOR
BACK OF WALL
MOUNTING PLATE
FINISH
MATERIAL
19
VENT
ELECTRICAL
OUTLET
BACK OF WALL
FIRESTOP
PLATE
RING
DETERMINE
THE
CORRECT
HEIGHT
W415-1337 / 06.23.14
EN