01
Before you start
Chapter 01:
Before you start
Checking what's in the box
Please check that you've received the following supplied
accessories:
• AM loop antenna
• FM wire antenna
• Dry cell batteries (AA size IEC R6) x2
• Remote control
• Warranty card
• These operating instructions
Loading the batteries
1
Open the battery compartment on the rear of the
remote control
2
Insert the supplied batteries following the
markings inside the battery compartment to align
them correctly.
3
Replace the battery compartment cover.
6
En
Important
Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
• Never use new and old batteries together.
• Insert the plus and minus sides of the batteries
properly according to the marks in the battery case.
• Batteries with the same shape may have different
voltages. Do not use different batteries together.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction's rules that apply in your country or
area.
Operating range of remote control
unit
The remote control may not work properly if:
• There are obstacles between the remote control and
the receiver's remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver is located near a device that is emitting
infrared rays.
• The receiver is operated simultaneously with another
infrared remote control unit.
30
30
21 ft. / 7m
Ventilation
The receiver should be properly ventilated to prevent
overheating.
• Do not place anything directly on top of the receiver.
• Do not use the receiver on a thick carpet or other soft
surface.