Setting Up The Network - Pioneer PDX-Z9 Mode D'emploi

Home Media Gallery
06

Setting up the network

1. Connect this unit to the
local area network (LAN)
(see page 21).
In case the router connected to the LAN terminal on
this receiver is a broadband router (with the built-in
DHCP server function), simply turn on the DHCP
server function, and you will not need to set up the
network manually. You must set up the network as
described below only when you have connected this
receiver to a server without the DHCP server function.
Before you set up the network, consult with your ISP or
the network manager for the required settings. It is
advisory that you also refer to the operation manual
supplied with your network component.
In case you make changes to the network configuration
without the DHCP server function, make the corresponding
changes to the network settings of this receiver.
IP Address
The IP address to be entered must be defined within the
following ranges. If the IP address defined is beyond the
following ranges, you cannot play back audio files stored
on components on the network or listen to Internet radio
stations.
Class A: 10.0.0.1 to 10.255.255.254
Class B: 172.16.0.1 to 172.31.255.254
Class C: 192.168.0.1 to 192.168.255.254
Subnet Mask
In case an xDSL modem or a terminal adapter is directly
connected to this receiver, enter the subnet mask
provided by your ISP on paper. In most of the cases, enter
255.255.255.0.
Gateway IP
In case a gateway (router) is connected to this receiver,
enter the corresponding IP address.
DNS Server Preferred/DNS Server Alternate
In case there is only one DNS server address provided by
your ISP on paper, enter 'DNS Server Preferred'. In case
there are more than two DNS server addresses, enter
'DNS Server Alternate' in the other DNS server address
field.
Proxy Hostname/Proxy Port
This setting is required when you connect this receiver to
the Internet via a proxy server. Enter the IP address of
your proxy server in the 'Proxy Hostname' field. Also,
enter the port number of your proxy server in the 'Proxy
Port' field.
30
En
Q: Is the connected
router equipped with
DHCP server operation?
• To delete alphanumeric characters entered one at a
• To return to the immediately previous setting menu,
• It may prove convenient to make a note of the
1
It may take several seconds for this receiver to access the
network.
2
3
ENTER.
The 'Network Connection' screen appears.
4
appears. Check the network connection status and
press
• Network Found – Connected to a component on the
• No Network Found – Not connected to a
The 'Network IP Settings' screen appears.
Set the router's DHCP server
function to ON (no settings
Yes
required on this receiver).
2. Make network settings.
No Consult the instructions below
and set the receiver as required.
Tip
time, press CLEAR.
press RETURN. When 'Cancel Key Editing Lose
Changes?' is display, press
previous setting menu (the previously set menu
contents will be canceled). Press
current setting menu.
addresses input in each step.
Press HOME MEDIA GALLERY.
Use to select 'SETUP' then press
WMP 1 1
F a v o r i t e s
4
S e t u p
4
Use to select 'Network Setup' then press
S e t u p
I n f o r ma t i o n
N e t wo r k S e t u
p
Either 'Network Found' or 'No Network Found'
.
network.
component on the network.
N e t wo r k Co n n e c t i o n
N e t wo r k F o u n d
to return to the
to return to the
.