Festool SYS-PST 1500 Li HP Notice D'utilisation page 25

Connect the charging cable [1-11] to the AC charging input [1-1] and mains
outlet.
If SYS‑PST 1500 Li HP still does not charge, contact the manufacturer or
service workshop (see section 10).
8 Storage
► Unplug the consumer.
► Remove the charging cable [1-11]
and store it in SYS‑PST 1500 Li HP.
► Activate transport mode: Set the
transport switch [1-13] to "0".
► Close the Systainer lid with the T-
Loc [1-5].
► Close the protective cap for the AC
charging input [1-1], the AC out­
put [1-2] and the DC output compat­
ible with USB‑C
► Do not store in a discharged state
for long periods of time. This can
lead to deep discharge and require
recommissioning by the manufac­
turer.
► Check the state of charge at least
every three months and charge if
necessary.
► Store in an environment with low
humidity and at a temperature be­
tween 0 °C and 23 °C.
9 Transportation
The Li-ion batteries included are sub­
ject to the requirements of the legisla­
tion on hazardous goods. The user must
familiarise themselves with the local
regulations prior to transport. Special
requirements apply to shipping via third
parties (e.g. air transport or haulage)
and these must be observed. When pre­
paring the item to be sent, a hazardous
goods expert must be consulted. Only
dispatch the machine if the battery is
undamaged. Observe local regulations
[1-6].
TM
when shipping. Observe any further na­
tional regulations.
► Unplug the consumer.
► Remove the charging cable [1-11].
► Open the Systainer lid with the T-
Loc [1-5].
► Activate transport mode: Set the
transport switch [1-13] to "0".
Modules are electrically separated from
each other.
► Store the charging cable [1-11]
in SYS‑PST 1500 Li HP.
► Close the Systainer lid with the T-
Loc [1-5].
► Only transport SYS‑PST 1500 Li HP
using the carrying handle [1-4].
The SYS‑PST 1500 Li HP can be trans­
ported on the road without additional
supports.
English
25