Avoiding Damage - Festool SYS-PST 1500 Li HP Notice D'utilisation

English
dled in accordance with the manufac­
turer's instructions.
–
Wear suitable personal protective
equipment: Safety shoes.
Only operate the machine within
–
the operating limits specified in the
technical data (see section 4).
– Charge the machine at regular in­
tervals to prevent hazards posed by
a deeply discharged battery.
– Do not tamper with the machine.
– Do not short-circuit the AC charging
input [1-1], AC output [1-3] and
DC output compatible with
[1-6].
USB‑C TM
Do not touch the AC charging in­
–
put [1-1].
Do not touch connections and elec­
–
trical contacts with fingers, jewel­
lery or other metal objects.
Do not store or set up in potentially
–
explosive environments.
Do not set up in standing water.
–
Keep the protective cap on the AC
–
output [1-2] closed during charg­
ing.
Keep the Systainer lid [1-5] closed
–
during operation and storage.
Avoid storage at high temperatures
–
(max. 45 °C). Keep the machine
away from external heat sources
(e.g. prolonged sunlight, fire).
Do not clean with liquids (in partic­
–
ular, do not use a pressure washer).
Do not use chemicals, fuels and lu­
–
bricants (e.g. for cleaning).
– This machine must not be used by
people who might have a particular­
ly adverse reaction to an electric
shock (e.g. people with cardiac
pacemakers), because the possibili­
18
ty of the machine and the connected
consumer building up a static
charge cannot be excluded.
People with disabilities or impair­
–
ments, as well as children, must
not operate this machine without
supervision.
Do not operate at altitudes exceed­
–
ing 2000 m above sea level.
Do not use as a step or ladder.
–
Do not use as a support or make­
–
shift workbench.
Do not hang from a crane.
–
– Do not dispose of the device or bat­
tery in a fire or hot oven, and do not
crush or cut them mechanically;
this may cause an explosion. For
correct disposal, see chapter 11.
2.2

Avoiding damage

– Do not open incorrectly. In particu­
lar, the guard [1-12] must not be
opened (unscrewed). Maintenance
and repair must only be performed
by trained specialists.
– Prevent damage due to falling. En­
sure stable footing on an anti-slip
surface and avoid the edges pro­
truding over the surface. Secure
against falling. The machine must
always be checked after falling to
see whether any parts are damaged.
If external damage is present, do
not continue using the machine. For
fall heights of 1.0 m or more, trans­
port mode must be activated: Set
the transport switch [1-13] to "0".
Additionally, contact customer serv­
ice (see section 10).
– Avoid damage caused by objects
accidentally falling on the machine
or the shipping container (incl. ma­
chine). A check must always be per­
formed after this kind of incident to