Led Indicator; Switching On/Off - Festool SYS-PST 1500 Li HP Notice D'utilisation

English
and another con­
sumer:
Combination
with a multiple
socket and one
consumer:
Combination
with a multiple
socket and sev­
eral consumers:
7 Operation
7.1 Checking the state of charge
► Open the Systainer lid with the T-
Loc [1-5].
► Deactivate transport mode: Set the
transport switch [1-13] to "I".
► Switch on (see section 7.3).
► Watch the LED indicator [1-9]
(see section 7.4).
7.2 Charging
Only use the supplied charging ca­
ble [1-11] for charging.
While the SYS‑PST 1500 Li HP is
charging, it cannot also be oper­
ated using the AC output [1-3].
If the charging cable is connected
during operation, the AC out­
put [1-3] is deactivated.
Observe the minimum required
charging power (see section 4).
7.4

LED indicator

LEDs off
22
No PRCD protec­
tive adapter nec­
essary.
PRCD protective
adapter [1-8] re­
quired for the
second and each
additional con­
sumer.
SYS‑PST 1500 Li HP switched off
or
completely discharged
► Open the Systainer lid with the T-
Loc [1-5].
► Deactivate transport mode: Set the
transport switch [1-13] to "I".
► Close the Systainer lid with the T-
Loc [1-5].
► Connect the charging cable [1-11]
to the AC charging input [1-1] and
mains outlet.
Charging process: LEDs light up green
in sequence from left to right.
Charged: LEDs off.
7.3

Switching on/off

Switching on
► Press the on/off switch [1-7].
SYS‑PST 1500 Li HP powers up or starts
and the LEDs [1-9] light up in the start
sequence.
Switching off
► Press the on/off switch [1-7].