Festool SYS-PST 1500 Li HP Notice D'utilisation page 19

see whether any parts are damaged.
If external damage is present or the
machine is malfunctioning, do not
continue using the machine.
2.3 If the machine has been
damaged
– Liquid may leak from defective bat­
teries. In this case, do not use the
machine and dispose of it correctly.
In the event of a battery fire, extin­
–
guish the fire with water. If possi­
ble, completely cover the machine
with water. Call the fire service and
inform them that the fire involves
lithium-ion batteries.
– There is a risk of vapours being re­
leased if the battery is damaged or
not used correctly. The vapours
may irritate your airways. Seek
fresh air and consult a doctor if you
feel unwell.
Fluid may leak out of the battery if
–
it is used incorrectly. Avoid contact
with the fluid. Rinse with water any
areas which accidentally come into
contact with the fluid. If fluid gets
into the eyes, also consult a doctor.
Leaking battery fluid can cause skin
irritation or burns.
2.4 Connecting consumers
Do not connect a consumer with
–
AIM technology (e.g. TKS 80 EBS
with SawStop AIM technology). AIM
technology only works with a pro­
tective earth connection and an
earthed power source.
Do not use to operate medical life
–
support machines.
– Do not connect any power genera­
tion systems.
For serial or parallel coupling (e.g.
–
with a mobile dust extractor), every
additional consumer must be con­
nected using a PRCD protective
adapter [1-8] and secured (see sec­
tion 6.3).
Use an antistatic suction hose when
–
connecting a mobile dust extractor.
Comply with local regulations for
–
safe operation of electrical con­
sumers at all times, especially for
operation of mobile power genera­
tors.
Use a consumer with restart pro­
–
tection if possible.
– Do not use faulty consumers. Con­
sumers, including the mains power
cable, must be in flawless technical
condition.
During operation with connected
–
consumers, ensure stable footing
(ensure good access to the connec­
ted consumer and sufficiently long
cable; do not place the charging ca­
ble and mains power cable under
tension).
– Before connecting consumers, en­
sure that the consumers are
switched off.
– Always switch off connected con­
sumers after use.
2.5 Information on charging the
machine
– Only use the provided charging ca­
ble [1-11] for charging.
Charge using low-voltage networks
–
(120‑240 V / 50 Hz).
3 Intended use
SYS‑PST 1500 Li HP is intended for
charging and operating mobile end de­
vices and power tools/consumers.
English
19