Connections; Power Supply; Telemetry (T/9 At Gr-18); Receiver Setup Menu - GRAUPNER GR-18 Notice D'utilisation

Masquer les pouces Voir aussi pour GR-18:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Connections

Connect the servos to the row of sockets on one end of the receiver. The connectors are polarised: note the small
chamfers on one side. Never use force - the connectors should engage easily. The polarity is also printed on the
receiver; the negative wire (-) is brown, the positive (+) red and the signal orange. The servo sockets of Graupner/SJ
HoTT 2.4 receivers are numbered sequentially.
The socket for channel 8 can also be programmed to deliver a (digital) sum signal (see section 3.2: Receiver set-up).
OK

Power supply

The receiver does not feature specific sockets for connecting the battery. We recommend that you connect the power
supply to the socket(s) close to the servos already connected to the receiver. If you wish to connect multiple separate
batteries, the batteries must be of the same nominal voltage and capacity. Never connect batteries of different type,
or packs of greatly differing states of charge, as this can cause effects similar to a short-circuit. If you encounter this
problem, we recommend the use of a voltage stabiliser unit (e.g. PRX-5A receiver power supply, Order No. 4136)
between the batteries and the receiver.

Telemetry (T/9 at GR-18)

The optional telemetry sensors are connected to the socket marked "T" (T/9)- Telemetry. In addition, the update is
performed on this socket (see point 5). At the GR-18, the socket can be used optionally for K9.

Receiver setup menu

Der Empfänger kann nur mit einem geeigneten HoTT-Sender oder in Verbindung mit der SMART-BOX (Best.-Nr. 33700)
programmiert werden.
menu GR-24
RECEIVER
1.0
>Type of Model:
ALARM VOLT:
ALARM TEMP:
max altitude:
>Period:
>SUMD at K8:
LANGUAGE:
34
The receiver set-up menu appears in
< >
the "Telemetry" menu under SETTINGS
Plane
/ DISPLAYS; alternatively - if you are
3.8V
using a SMART-BOX - under SETTING
70°C
& DATAVIEW. The method of accessing
125m
10ms
this menu is described in the operating
No
instructions supplied with your transmitter
english
or the Smart-Box.
menu GR-18
RECEIVER
1.0
< >
>Type of Model:
Plane
ALARM VOLT:
ALARM TEMP:
max altitude:
>Period:
>SUMD at K6:
Sensor at K9:
LANGUAGE:
english
3.8V
70°C
125m
10ms
No
No

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gr-24 pro3357933583

Table des Matières