Log Placement - Napoleon GD36NTR Instructions D'installation Et D'opération

44
7.3

LOG PLACEMENT

EN
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
TM logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
PHAZER
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
Place the back log (#1) onto the log support
A.
tray and in front of the tabs. The tabs
maintain an air space between the log
and fi rebox back to facilitate combustion air
fl ow. Ensure that the back of the log rests
against the brackets on the back wall of the
fi rebox.
Position the front right log just behind the
C.
grate lining up the holes in the bottom with
the studs located on the log support.
Line up the square hole in the right crossover
E.
with the square post located on the right side
of log and install as shown.
W415-0773 / F / 08.26.13
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
1
1 3
2
5
1
4
3
2
WARNING
!
Move the charcoal strip into position lining
B.
up the holes in the bottom with the studs
located on the burner on the burner. Ensure
strip sits fl at on the burner.
4
Move the left log into position lining up the
D.
hole in the bottom with the stud on the left
side of the log support.
Line up the rectangular hole in the left
F.
crossover with the rectangular post located on
the left side of log and install as shown.
76.1A
1
2
1
3
2
6
5
1
4
3
2