Napoleon GD36NTR Instructions D'installation Et D'opération page 34

34
It is best to frame your appliance after it is positioned and the vent system is installed. Frame to local building
codes.
It is not necessary to install a hearth extension with this appliance system.
EN
When roughing in the appliance, raise the appliance to accommodate for the thickness of the fi nished fl oor
materials, i.e. tile, carpeting, hard wood, which if not planned for will interfere with the opening of the lower
access door and the installation of many decorative fl ashing accessories.
Combustible materials may be installed fl ush with the front of the appliance but must not cover any of the
black face-areas of the appliance. Non-combustible material (brick, stone or ceramic tile) may protrude in
these areas.
Minimum clearance to combustible construction from appliance and vent surfaces:
Combustible Framing:
-
-
-
Combustible Finishing:
-
-
-
Rear Exit
-
-
Top Exit
-
-
* GD36 HORIZONTAL VENT SECTIONS: A minimum clearance of 1" (25mm) at the bottom and sides and 2"
(51mm) at the top of the vent pipe on all horizontal runs to combustibles is required. Use fi restop spacer W010-
1777 (supplied).
* GD36 VERTICAL VENT SECTIONS: A minimum of 1" (25mm) all around the vent pipe on all vertical runs
to combustibles is required except for clearances in appliance enclosures. See "MINIMUM ENCLOSURE
CLEARANCES" section. Use fi restop spacer W500-0096 (not supplied).
W415-0773 / F / 08.26.13
0" to stand-offs
1" (25mm) to bottom and sides of the vent pipe*
2" (51mm) to top of the vent pipe*
0" to rear
0" to front face top and sides
14 1/4" (362mm) recessed depth
42 1/4" (1073mm) to enclosure top from base of the appliance
54" (1372mm) to ceiling from base of the appliance
63" (1600mm) to enclosure top from base of the appliance
54" (1372mm) to ceiling from base of the appliance