Pratissoli MK Serie Manuel De Réparation page 45

Unscrew the con-rod screws (pos. , Fig. 23).
Remove the con-rod caps with the semi-bearings, taking
special care of the disassembly sequence during disassembly.
The con-rod caps and their relative half
supports must be reassembled in exactly the
same order and coupling with which they were
disassembled.
To avoid possible errors, caps and half supports have been
numbered on one side (pos. , Fig. 24).
Advance the half supports in the direction of the hydraulic
part to allow the shaft to come out. To facilitate this operation,
use special tool (code 27566200), (pos. , Fig. 25).
Fig. 23
Remove the pressure bush (pos. , Fig. 26).
Remove the three upper half-bearings of the half supports
(pos. , Fig. 27).
Fig. 24
45
Fig. 25
Fig. 26
Fig. 27