Pratissoli MK Serie Manuel De Réparation page 75

Make sure that the cover completely enters its seat (pos. ,
Fig. 172) being careful not to damage the lip of the seal ring.
Screw in the oil seal covers using 2 x M6x14 screws (pos. ,
Fig. 173).
Calibrate the screws with a torque wrench as indicated in
chapter 3.
Position the spray-guard together with the O-ring in the
housing on the piston guide (pos. , Fig. 174 and Fig. 175).
Insert the Ø10x18x0.9 washer in the piston fixing screw
(pos. , Fig. 176).
Fig. 172
Install the pistons on their respective guides (pos. , Fig. 177)
Fig. 173
and fasten them as per pos. , Fig. 178.
Fig. 174
75
Fig. 175
Fig. 176
Fig. 177