Kingspan TRZ Plus 2A Manuel D'utilisation page 59

Connecting Multisensor (MS) for measurement of Humidity [%],
CO -Quality [ppm] und Temperature [C°] for the room air
2
All work to be carried out without mains supply (230 V AC) or any batteries connected. Route the connecting cables
into the control panel housing at the top. Connect all connecting cables according to the wiring diagram and make sure
that they are correctly connected. Incorrected connections or figure or colour mix-ups can lead to incorrect function of
the control panel or of the external components. The notes and installation directives in the technical documentation are
always to be observed.
Variant 1:
Standard connections for the power supply of the multisensor. Notes to the DIP switches are observed.
Are an external buzzer or flashing light connected to signal an SHE message to these terminals, the energy supply
of the terminals to the additional board WRMAS is apparent (see Option 2).
MS
6
Note: When using terminals 20 and 21 to the power of the multisensor,
the DIP switch must be set 3 + 9 of ON.
Variant 2:
Energy supply for the multisensor to the terminals of the additional board WRMAS to power a wind rain detector.
A wind-/rain sensor must not be connected together with a multisensor at these terminals. In this case,
the connection variant 1 is to be chosen.
MS
6
Note: Detailed information to the multisensor, refer to the documentation.
59
SHE control panel TRZ Plus 2A and TRZ Plus Comfort;
Compact control panel 2A and Compact control panel 2A/M
Multisensor
Ensure jumper
position !
Multisensor
Ensure jumper
position !
TRZ WRMAS
open close
S P Ö S P
20 21 11 10
á
á
Auf Zu
Ö
S P S P
11 10
á
á
20 21 22 23
-
+
Ö
8
Ö
8
13/24999513