Connecting Diagram Fire Alarm System - Kingspan TRZ Plus 2A Manuel D'utilisation

Connecting diagram Fire Alarm System

All work to be carried out without mains supply (230 V AC) or any batteries connected. Route the connecting cables into
the control panel housing at the top. Connect all connecting cables according to the wiring diagram and make sure that
they are correctly connected. Incorrect connections or figure or colour mix-ups can lead to incorrect function of the
control panel or of the external components. The notes and installation directives in the technical documentation are
always to be observed.
without fire alarm system
+
18 19
10kΩ
D
BMA
GB
FAS
+
18 19
DK
ABA
active end modul / 2
till Firmware V01.00.11: DIP-Switch11 = ON
from Firmware V01.00.12 used as
standard: DIP-Switch 11 = OFF
10 kΩ Monitoring resistor
till Firmware V01.00.11: DIP-Switch 11 = OFF
from Firmware V01.00.12: DIP-Switch 11 = ON
FAS: Fire Alarm System
* Impulse contact, not for "FAS Open" and "Reset by closer contact", switch DIP-Switch 4 to ON.
13/24999513
SHE control panel TRZ Plus 2A and TRZ Plus Comfort;
Compact control panel 2A and Compact control panel 2A/M
with fire alarm system
UEB2 UEB2 UEB2
UEB3-1K-AE
t ~ 2 sec.
FAS
UEB3-1K-AE
+
18 19
UEB3-1K-AE
with fire alarm system and
smoke detectors
*
UEB3-1K-AE
+
18 19
UEB2 UEB2 UEB2
UEB3-1K-AE
*
t ~ 2 sec.
FAS
SSD 521
UTD 521
UTD 523
MSD 523
55