Safety Measures; Modifications - Mettler Toledo InPro 8600i Serie Mode D'emploi

14
© 07 / 16 Mettler-Toledo GmbH, CH-8902 Urdorf
Printed in Switzerland

2.12 Safety measures

Notice: Always observe and comply with local laws and regulations!
These are not an integral part of this instruction manual.
The operator is responsible for the instruction of personnel. Additional copies of this instruction
manual can be ordered from the equipment supplier. As an integral part of the sensor, this
instruction manual must at all times be readily accessible to users at the point of operation of
the sensor.
The operator is obliged to inform the supplier/manufacturer of the sensor immediately about any
safety-relevant incidents, or observations made, during use of the sensor.
Danger! Incorrect manipulation and/or instruction errors can lead to potential hazards for
persons and for the environment.
Before every start-up the sensor must be checked for:
– damage to the connections, fastenings, etc.
– leakage
– defective cables and lines etc.
– authorization for use of the sensor in conjunction with the associated plant resources.
Caution! A defective sensor must never be installed or put into operation. Poor
containment, leaky connections etc. or non-compliant installation of the sensor can
lead to escape of process medium and thereby to a potential threat to life.

2.13 Modifications

Notice: No attachments or modifications to the sensor housings are allowed.
Danger! The manufacturer/supplier accepts no responsibility for any damage caused by
unauthorized attachments and alterations or for the incorporation of spare parts which
are not of METTLER TOLEDO provenance. The risk is borne entirely by the operator.
InPro 8600 i Series
InPro 8600 i Series
30 113 529