Mettler Toledo InPro 8600i Serie Mode D'emploi page 5

InPro 8600 i Series
How to use this instruction manual
InPro 8600 i Series
30 113 529
This instruction manual is an integral part of the METTLER TOLEDO InPro 8600 i sensors and
contains notes and instructions that are important for safety and operation.
All persons working on or with the InPro 8600 i sensor must have first read and understood the
sections appropriate to the work in hand.
Please read this instruction manual carefully before using the InPro 8600 i sensor. Keep this
document close to the unit, so that operating personnel may easily be able to refer to it at any
time.
Please first read section 1 "Introduction" and section 2 "Safety".
Proprietary designations
The following are proprietary names and, for the sake of simplicity, will be mentioned in this
instruction manual without the registration marking, e.g.
– InPro ® is a registered trade mark of Mettler-Toledo GmbH, CH - 8606 Greifensee, Switzerland.
Explanation of sensor designations
The general designation InPro 8600 i used in this instruction manual refers to the following tur-
bidity sensor models:
– InPro 8600 i / D1: digital interface version, single-angle
– InPro 8600 i / D3: digital interface version, dual-angle plus colour
® :
© 07 / 16 Mettler-Toledo GmbH, CH-8902 Urdorf
Printed in Switzerland
5