Commissioning Of Version With Planetary Gear F 550 Gs And F 560 Gs; Commissioning Of Version With Bearing Flange - FLUX F 550 Serie Notice D'instructions

5.4

Commissioning of version with planetary gear F 550 GS and F 560 GS

Available drive motors in hazardous areas:

Commutator motors

Brushless motor

Compressed air motors
> Put the motor onto the pump.
> Firmly tighten union nut by hand.
> Immerse the pump into the container.
> Insert the plug or connect the air supply hose.
> Switch on the motor.
5.5

Commissioning of version with bearing flange

Available drive motors in hazardous areas:

Ex-proof three-phase motors 0.75 to 1.1 kW, 700 or 930 rpm

Compressed air motors FPM 4 Ex, FPM 6 Ex, FPM 8 Ex,
maximum speed 1000 rpm
Attention!
 Only suitably qualified personnel should carry out installation,
> Only use three-phase motors with a starter including an overload cutout switch.
> Make sure that the supply voltage corresponds to the voltage indicated on the
nameplate.
> When using compressed air motors please do not exceed the maximum operating
pressure of 6 bars and use filter-regulator-lubricator unit.
Attention!

> Clean bearing flange and motor flange. Fit the motor onto the bearing flange and
tighten the screws.
> Immerse the pump into the container.
Centering at the
bearing flange
> Insert the plug or connect the compressed air hose.
> Switch on the motor.
40/88 Original operating instructions Eccentric worm drive pump F 550 and Sanitary pump F 560
F 460 Ex, F 460 Ex EL, F 460-1 Ex
FBM 4000 Ex
F 416 Ex, F 416-1 Ex, F 416-2 Ex
maintenance and repairs to three-phase motors.
Check direction of rotation of the motor. In case of portable use,
check the conformity of phases at each socket to guarantee always
the same direction of rotation.
(Direction of rotation according to the arrow on the bearing flange).
Motor
Direction of
rotation arrow
Bearing flange
4 screws with hexagonal
recessed hole