Commissioning Of Version With Planetary Gear F 550 Gs And F 560 Gs; Commissioning Of Version With Bearing Flange F 550 S And F 560 S - FLUX F 550 Notice D'instructions Originale

Note
Explosion protection at the connection point is not necessary if the power
socket or the terminal box are clearly located outside the hazardous area.

3.3 Commissioning of version with planetary gear F 550 GS and F 560 GS

Available drive motors:
• Commutator motors
• Brushless motor
• Compressed air motors
• Three-phase motor
> Put the motor onto the pump.
> Firmly tighten union nut by hand.
> Insert the plug or connect the air supply hose.
> Switch on the motor.

3.4 Commissioning of version with bearing flange F 550 S and F 560 S

Available drive motors:
• Three-phase motors 0,75 to 1,1 kW, 700 or 930 rpm
• Compressed air motors FPM 4 Ex, FPM 6 Ex, FPM 8 Ex,
maximum speed 1000 rpm.
Attention!
•
• Only use three-phase motors with a starter including an overload cut-out switch.
• Make sure that the supply voltage corresponds to the voltage indicated on the name
plate. When using compressed air motors, please do not exceed the maximum ope-
rating pressure of 6 bars and use filter-regulator-lubricator unit.
• Check direction of rotation of the motor. In case of portable use, check the conformity
of phases at each socket to guarantee always the same direction of rotation.
(Direction of rotation according to the arrow on the bearing flange).
• Clean bearing flange and motor flange. Fit the motor onto the bearing flange and
tighten the screws.
FEM 4070, F 457, F 457 EL, F 458, F 458 EL, F 458-1,
F 460 Ex, F 460 Ex EL, F 460-1 Ex
FBM 4000 Ex
F 416 Ex, F 416-1 Ex, F 416-2 Ex
F 403
Installation, maintenance and repairs to three-phase motors should only be
carried out by suitably qualified personnel.
Original Manual High Viscosity Liquid Pumps Type F 550
and Sanitary Pumps Type F 560 31 / 84