Ravaglioli RAV307H.4WS-VARSC Traduction Des Instructions Originales page 64

D) From "GROUP" mode to "ALL" mode
1) the display shows:
H e i g h t 1 1 1 1
the following is displayed:
1 A l l M o d e
> > 2 G r o u p
> > 1 A l l M o d e
2 G r o u p
the following is displayed:
> > A L L R E Q
E x i t
Selecting the ALL mode, the following is displayed:
> > A L L M O D E
S E L E C T E D . .
2) Repeat the operations on all the columns that are entered in GROUP mode.
- ATTENTION: If the columns in "GROUP" mode are turned off and then turned on again, they will be set to "ALL" mode.
Simultaneous configuration of two or more power lifts
It is not possible.
If 2 master columns with open configuration are detected, the procedure is blocked.
All installations must be switched off.
Repeat the operation, close the configuration of the bridge before starting the set of a new machine.
64
mm
G R O U P
Press the black "ENTER" key
M o d e < <
move up with the yellow key
< <
M o d e
confirm with the black "ENTER" key
? < <
confirm with the black "ENTER" key
< <
, to
0526M002-2
(VARSC)
7