Configuration Setup - Ravaglioli RAV307H.4WS-VARSC Traduction Des Instructions Originales

Configuration setup

N.B.: The columns must always have an even number (minimum 4 and maximum 8)
A) New configuration
Only possible if the trolleys are all on the descent limit switches.
As first operation, to determine the MASTER column and the subsequent SLAVE columns.
1) When starting the switchboard, the following shall appear on the display:
> > O L D C o n f i g
N E W C o n f i g
O L D C o n f i g
> > N E W C o n f i g < <
The following is displayed:
> > C o l M A S T E R
C o l S L A V E
The system starts on the "Chanel 2" configuration radio channel.
The operator can choose a different radio channel than the one proposed using the Red
crease or increase the number of the radio channel). NB: Available radio channels (3-4-5-6-7-8-9).
> > C h a n n e l
W a i t S l a v e s
to select/configure the SLAVE columns.
2) Shift to another column, when starting the switchboard the display shall show the following:
> > O L D C o n f i g
N E W C o n f i g
O L D C o n f i g
> > N E W C o n f i g
the following is displayed:
> > C o l M A S T E R
C o l S L A V E
C o l M A S T E R
> > C o l S L A V E
Now the SLAVE column receives from the MASTER column the configuration message and the display shows:
> > C h a n n e l
C o l u m n
The message indicates which channel is the Radio channel that shall be used at the end of the configuration process (Channel 2)
and the ID that will be assigned to the column (Column 2).
After you have verified that the proposed channel is the same
as the MASTER column, you must confirm the details by pressing the black "ENTER" key
> > I D 2 C H
S e l e c t e d
N.B.: The operator must repeat the operations at point 2 for all columns of the power lift.
< <
move down with the blue Key
confirm with the black "ENTER" key
< <
determine the MASTER column by pressing the black "ENTER" key
2 < <
Now the display shows "Wait SLAVE", which means that the system is waiting for you
< <
move down with the blue key
< <
confirm with the black "ENTER" key
< <
move down with the blue button
< <
confirm the SLAVE column by pressing the "ENTER" black key
2 ?< <
2
2 < <
confirm the correct configuration of the SLAVE 2 column
, to
, to
, to
0526M002-2
and Green buttons (to de-
and the display will show:
7
53