Ravaglioli RAV307H.4WS-VARSC Traduction Des Instructions Originales page 57

D) From "GROUP" mode to "ALL" mode
1) the display shows:
H e i g h t 1 1 1 1
the following is displayed:
1 A l l M o d e
> > 2 G r o u p M o d e < <
> > 1 A l l M o d e
2 G r o u p M o d e
the following is displayed:
> > A L L R E Q
E x i t
Selecting the ALL mode, the following is displayed:
> > A L L M O D E
S E L E C T E D . .
2) Repeat the operations on all the columns that are entered in GROUP mode.
- ATTENTION: If the columns in "GROUP" mode are turned off and then turned on again, they will be set to "ALL" mode.
E) Using two or more power lifts (power lifts signify a set of 4, 6, or 8 columns)
The communication shall be performed on different channels, the first configured power lift shall communicate on channel 2, and
the others on different channels (available from 0 to 9).
When a power lift is switched off and a new configuration is performed on another one, the transmission may take place on the
channel of the switched off power lift.
When it will be re-started, a new communication channel shall be suggested, which will be confirmed on all the columns in the set.
F) Simultaneous configuration of two or more power lifts
It is not possible.
If 2 master columns with open configuration are detected, the procedure is blocked.
All installations must be switched off.
Repeat the operation, close the configuration of the bridge before starting the set of a new machine.
mm
G R O U P
Press the black "ENTER" key
move up with the yellow key
< <
confirm with the black "ENTER" key
? < <
confirm with the black "ENTER" key
< <
, to
0526M002-2
7
57