Troubleshooting - Angelcare AC117 Manuel De L'utilisateur

6.3 - PAGER
Allows you to locate the Parent Unit.
Press and hold
the Temperature
Light button

TROUBLESHOOTING

TAKING CARE OF YOUR RECHARGEABLE BATTERIES
• Ensure that you fully charge your batteries for 10 hours before their first use.
• To maintain maximum battery life it is recommended that you fully discharge your
batteries periodically. Battery performance can be diminished by leaving the batteries
constantly charging. If your Parent Unit is not in use, please turn it off.
• Inadequate battery power can impair the performance of your monitor. If you are
not happy with the performance of your Parent Unit please replace the rechargeable
batteries (2 x NiMH Rechargeable Batteries).
• It is advisable to change the batteries every 6 months.
LOSS OF CONNECTIVITY BETWEEN THE PARENT UNIT AND THE NURSERY UNIT
• In the case of loss of connectivity, the first step is to bring the Parent Unit and Nursery
Unit closer together and make sure that both units are ON to restore the connection. If
there is still no connection and no out-of-range warning after the above has been done,
then and only then should the re-connection procedure below be done.
20
TO LOCATE THE PARENT UNIT
Press and hold the Temperature Light
button on the side of the Nursery Unit.
The Parent Unit will emit a paging
sound.
TO STOP THE PAGING SOUND
Press any button on the Parent Unit or
the Pager button on the Nursery Unit.
Power On/Off Light Indicator
Low Battery Light Indicator
Flashing green
Flashing yellow Nursery Unit batteries are low
Steady green
Sensor Pad Light Indicator
Temperature Indicator
Flashing red
Flashing white
Loss of connectivity between the
Flashing light blue
Nursery unit and the Sensor Pad
Steady Red Room temperature is too hot
Steady Blue Room temperature is too cold
Steady White Room temperature is good
Nursery unit is using the
back-up batteries
Monitor is activated
No movement is detected
Monitor is paused