Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TROUBLESHOOTING

TAKING CARE OF YOUR RECHARGEABLE BATTERIES
• Ensure that you fully charge your batteries for 15 hours before their first use.
• To maintain maximum battery life it is recommended that you fully discharge your
batteries periodically. Battery performance can be diminished by leaving the batteries
constantly charging. If your parent unit is not in use, please turn it OFF.
• Inadequate battery power can impair the performance of your monitor. If you are
not happy with the performance of your Parent Unit/Monitor please replace the
rechargeable batteries (4 or 8 x NiMH Rechargeable Batteries).
• It is advisable to change the batteries every 6 months.
LOSS OF CONNECTIVITY
• In the case of loss of connectivity, the first step is to bring the Parent Unit and
Nursery Unit closer together and make sure that both units are ON to restore
the connection. If there is still no connection and no out of range warning after the
above has been done, then and only then should the re-connection procedure below
be done.
Re-connection procedure:
1
2
4
FALSE ALARMS
• Turn OFF the Nursery Unit.
• Verify the connection between Sensor Pad and the Nursery Unit. Unplug and reconnect
the cord.
• Make sure there is no bedding between mattress and the Sensor Pad.
• If the crib has a spring or slat base, place a hardboard between the crib base and the
Sensor Pad measuring at least 13" x 13" (33 x 33 cm) and 1/4 inch (6 mm) thick.
• Make sure Sensor Pad is positioned as described under the setup requirements.
Sensitivity may need to be adjusted, refer to Step 5.3.
1) Turn the Nursery Unit and the Parent Unit
2) Turn ON the Parent unit - press and hold
3
3) Turn ON the Nursery Unit and - press and
4) You will know your reconnection was
OFF.
the MENU button. The Out-of-Range
alarm will flash and you will hear a beep.
hold the top button to reconnect. The TIC
light will flash within a few seconds and
you will hear a confirmation beep.
successful when C1 appears on the Parent
Unit display, then normal screen will
appear.
NOTE:
The connection process should be done
within 30 seconds, if you ignore or it takes
longer then you will need to restart the
steps.
E
N
25

Publicité

Table des Matières
loading

Table des Matières