Angelcare AC117 Manuel De L'utilisateur page 4

stand, tripod, bracket or table. The product may
fall, causing serious injury to a child or adult and
serious damage to the product. Use ONLY with a
cart, stand, tripod, bracket or table recommended
by the manufacturer or sold with the product.
Any mounting of the product should follow the
manufacturer's instructions.
15.9 Unplug this appliance during lightning storms
or when not used for long periods of time.
15.10 Servicing - DO NOT attempt to service
this product yourself as opening or removing
covers (except battery door) may expose you to
dangerous voltage or other hazards.
15.11 Replacement parts - When replacement
parts are required, be sure the replacement parts
specified by the manufacturer have the same
characteristic as the original part. Unauthorized
substitution may result in fire, electric shock or
other hazards.
15.12 Usage - This baby monitor is intended as
an aid. It is NOT a substitute for responsible and
proper adult supervision and should not be used
as such. Use this appliance ONLY for its intended
use as described in this manual.
15.13 Power Sources - Operate this product only
from the type of power source indicated on the
type plate of the adaptor. If you are unsure of the
type of power supply to your home, consult your
dealer or local power company.
15.14 Overloading - DO NOT overload wall
outlets, extension cords or integral convenience
receptacles as this can result in a risk of fire or
electric shock.
15.15 Object and Liquid Entry - NEVER push
objects of any kind into this product through
casing slots as they may touch dangerous voltage
points or short out parts that could result in a risk
of fire or electric shock. NEVER spill liquid of any
kind on the product.
15.16 Antenna - The antenna used for this
transmitter must be installed to provide a
separation distance of at least 7.9" (20 cm) from all
persons and must not be collocated or operating in
conjunction with any other antenna or transmitter.
15.17 Power Lines - An outside antenna system
should NOT be located in the vicinity of overhead
power lines or other electric light or power circuit,
or where it can fall into such power lines or circuits
as contact with them may be fatal.
15.18 Vibration Source - When the monitor is in
use, DO NOT use a bedside crib, crib mobile or
other crib accessories that may produce vibrations.
Other sources of vibrations may include fans,
washing machines, loud music, etc. These sources
of vibration may interfere with the performance
of your Angelcare
not sound if it continues to detect any movement
other than your baby's. Be sure all vibration
sources are eliminated before using the monitor.
You may experience false alarms for several reasons.
The most common reason is the Nursery Unit has
not been turned OFF after you have removed your
baby from the crib. Another reason is the Sensor Pad
has not been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm surface with
the Angelcare ® logo side facing up. The sensitivity
level may also need to be adjusted. Refer to
Step 5.1. Always be sure to immediately check on
baby whenever an alarm sounds.
4
monitor and the alarm will
®
15.19 Sensor Pad - Your Sensor Pad can be used
in any crib that is stationary. If the crib has a
spring or slat base, place a hard board between the
crib base and the Sensor Pad measuring at least
13'' x 13'' (33 x 33 cm) and 1/4'' (6 mm) thick. Only
use your Angelcare
®
sleeping environment such as a crib where the
Sensor Pad can rest on a completely flat, firm
surface. The Sensor Pad is made of plastic and
does not permit the air to circulate. Therefore,
mildew build up could develop underneath the
mattress in the Sensor Pad area. We suggest
rotating the mattress regularly to prevent any
mildew.
16. I M P O R TA N T S A F E T Y
RELATED TO USE OF BATTERIES
16.1 Use ONLY the type and size of battery
specified in the owner's manual. There is a risk
of explosion if battery is replaced with an incorrect
type.
16.2 Charge the battery for 10 hours prior to first
use. Be sure to have the monitor in the OFF position
during this period. ONLY use the adapters included
with your monitor.
16.3 DO NOT use these adapters with any other
equipments.
16.4 When unplugging the adapter from the
Nursery Unit, be sure it is switched to the OFF
position.
16.5 DO NOT dispose batteries in fire. They may
explode. Check with local regulations for possible
special disposal instructions.
16.6 Exercise care in handling batteries in order
not to short out the batteries with conducting
materials such as rings, bracelets and keys.
Overcharging, short circuiting, reverse charging,
mutilation, or incineration of batteries must be
avoided to prevent one or more of the following
occurrences: release of toxic materials, release of
hydrogen and/or oxygen, gas and rise in surface
temperature.
16.7 DO NOT attempt to rejuvenate the battery
provided with or identified for use with this
product by heating them. Sudden release of
battery electrolyte may occur, causing burns or
irritation to eyes or skin.
16.8 If and when necessary, the battery must be
replaced with identical new ones or equivalent
(volts and size).
16.9 Reverse polarity installation of the batteries
in the end product must be avoided. Reverse
insertion of batteries can cause charging, and
that may result in leakage or explosion.
16.10 Remove the battery from the Parent Unit
if you store the product over 30 days because
the battery could leak and damage the product.
16.11 Discard 'dead' batteries as soon as possible
since 'dead' batteries are more likely to leak in a
product. If a battery has leaked or vented, it should
be replaced immediately using protective gloves.
16.12 D O N OT s to re this p ro d u c t , o r th e
battery provided with or identified for use
with this product, in high-temperature areas.
monitor in a stationary
I N S T R U C T I O N S