Troubleshooting - Angelcare AC423-D Manuel De L'utilisateur

TROUBLESHOOTING

TAKING CARE OF YOUR RECHARGEABLE BATTERIES
• Ensure that you fully charge your batteries for 15hrs before their first use.
• To maintain maximum battery life it is recommended that you fully discharge
your batteries periodically. Battery performance can be diminished by leaving
the batteries constantly charging. If your parent unit is not in use, please turn it off.
• Inadequate battery power can impair the performance of your monitor. If you are not
happy with the performance of your Parent Unit/Monitor please replace the rechargeable
batteries (3 x NiMH Rechargeable Batteries).
• It is advisable to change the batteries every 6 months.
LOSS OF CONNECTIVITY
In the case of loss of connectivity, the first step is to bring the Parent Unit and Nursery Unit
closer together and make sure that both units are ON to restore the connection. If there is
still no connection and no out of range warning after the above has been done, then and
only then should the re-connection procedure below be done.
Re-connection procedure:
2
2
6
6
Note: If step 4 is not followed within the duration, the Parent Unit will exit the connectivity
mode and you will need to start this process again.
58
All manuals and user guides at all-guides.com
3
3
4
4
1
1
Der Schutzengel im Kinderzimmer
AC423-D
1. Turn ON both the Nursery Unit and
the Parent Unit.
2. By pressing and holding for 3 seconds
5
the Parent Unit "CHANNEL KEY (CH)"
5
button, the Parent Unit will be set in
1
to connectivity mode.
1
3. LCD will only show '——' to indicate
that the Parent Unit is in the channel
selection mode with back light on and
the Antenna icon will flash.
4. To set the Nursery Unit into
connectivity mode, press and hold
the Page button for 4 seconds (on the
back of the Nursery Unit). The Power
LED will flash to indicate the channel
selection mode is on. On the Parent
Unit, you will then see the channel
being used by the Nursery Unit.
5. Press and hold the back button of
the Nursery Unit again to confirm the
registration.
6. When the Parent Unit and Nursery
Unit are connected, the Parent Unit
emits a confirmation tone and will
show the channel number which
will be replaced by the temperature
(normal screen) a few seconds later.
®