Angelcare AC117 Manuel De L'utilisateur page 21

3
6
LOSS OF CONNECTIVITY BETWEEN THE NURSERY UNIT AND THE WIRELESS SENSOR PAD
• In the case of loss of connectivity, the first step is to bring the Sensor Pad and Nursery
Unit closer together and make sure that both units are ON to restore the connection. If
there is still no connection after the above has been done, then and only then should the
re-connection procedure below be done. Make sure that no other wireless Sensor Pad is
in the same room during the reconnection procedure.
4
1) Turn both Units OFF.
2) Turn the Nursery Unit ON.
3) Press 4 consecutive times the Power
ON/OFF button on the Nursery Unit.
4) Turn the Parent Unit ON.
5
5) Press and hold the Talk Back button
on the Parent Unit until a beep tone is
heard.
6) Press OK button on the Parent Unit.
The Parent Unit will display H1-H2 icon during
the reconnection procedure. The reconnection is
successful if Parent unit shows regular screen view.
1) Turn both Units OFF.
2) Remove the battery from the Sensor Pad.
5
3) Replace the battery in the Sensor Pad.
4) Turn the Nursery Unit ON by pressing
2 seconds on the Power ON/OFF button.
The Sensor Pad
Indicator Light on
the Nursery Unit will
flash quickly in green
(indicates Nursery Unit
is in linking mode).
GREEN
Out-of-range icon will blink
(indicates Nursery Unit is in
linking mode).
Out-of-Range icon should blinks
faster to indicate that the Parent
Unit is in linking mode.
Power Indication of the
Nursery Unit will turn green.
E
N
21