Operation; Startup - Enarco TEN2540 Manuel D'instructions

6

OPERATION

6.1 BEFORE COMMENCING WORK
6.1.1.
Special ATTENTION should be paid to the underside of the vibrating plate and the areas adjacent to
the air coolant intake for the motor, the carburettor and the air filter.
6.1.2.
6.1.3.
6.1.4.
6.1.5.
6.1.6.
Change the oil while it is hot. In order to make it easier for the used oil to come out, tilt the machine
and tap the vibrator.
6.1.7.
6.2

STARTUP

- HONDA GX160 / ROBIN EX17 MOTOR
6.2.1.
6.2.2.
6.2.3.
REVERSIBLE PLATE COMPACTORS
TEN2540-TEN2550-TEN3040-TEN3050
Clean off all the dirt, mud, etc. from the unit before commencing work.
Check all the screws and make sure that they are tightened properly. Loose screws can
damage the machine.
Check the tension in the V-belt. Normal oscillation should be 10 – 15 mm (1/2") when
pressure is applied to the belts halfway between the two pulleys. If there is too much play
in the belts, there may be a lack of impact or uncontrolled vibration, causing damage to
the machine.
The state of the air filter.
Check the oil level in the motor, and if low, top it up. The motor has a 0.6 l oil capacity.
SAE10W/40 engine oil should be used.
Make sure that the compaction plate is level during inspection. The oil level in the vibrator
should reach the level of the stopper. Change the oil once a month or after every 200
hours' work. The vibrator has a 1000 cc capacity.
IMPORTANT USE SAE 100 OIL
Normal unleaded petrol should be used in the motor. When re-filling the petrol tank,
make sure the filter is in use.
Open the fuel cock by moving the lever to the half-open position. In order to start up the
motor when it is cold, move the lever for regulating the air to the closed position. When
the motor is hot, the air regulator should be either half or completely open. If it is difficult
to start the motor up, make sure that the lever for regulating the air is half open to stop
the carburettor from flooding due to an excessive amount of fuel.
When pulling on the ignition cord, do not pull it all the way, since this could damage the
recuperator spring. Do not let go of the cord suddenly to repeat the startup procedure
once the motor has been ignited: keep hold of the handle and slowly let go until it retracts
completely.
After starting up the motor, gradually open up the air control lever again. Leave the motor
to warm up at minimum speed for 3-5 minutes. This procedure for warming up the motor
with minimum revolutions is particularly important during the cold season. While the
motor is warming up, the machine should be given a general inspection to detect any
anomalies.
en
13