Operation; Getting Started; Operation Conditions - Enarco VIB-BAR E-BATT Manuel D'instructions

13. Keep the air inlet and outlet of the motor clean.
14. Read the user manual before starting the work.
15. The acoustic power level of these machines could be a risk for health. According to the standard
16. The hand-arm vibration level of these machines could be a risk for health. Hand-arm vibration
17. The parts used for isolating from vibration must be maintained in perfect shape. In case of
FURTHERMORE, THE OPERATOR IS COMPELLED TO RESPECT ADDITIONAL REGULATIONS ENFORCED

5 OPERATION

5.1 GETTING STARTED

en

5.2 OPERATION CONDITIONS

For your own safety and as the protection of others and not to cause damage to the equipment, please
read the conditions of use of this machine carefully.
VIB-BAR E-BATT – FLEXIBLE SHAFT AND POKER
ABP38
8
TBP0.5m / VIB-BAR
ISO3744, accoustic pressure level (LpA) in the workplace is 79,01dB (K=0). The test is made on
the motor working at the maximum speed and with the poker ABP38. Proper protective equipment
must be used.
figures are below 2,5 m/s2. The test is made on the motor working at the maximum speed, with
the poker ABP38 hanging on air (according to ISO5349) and held on the handle by the user
2
(K=1m/s ).
damage, they must be replaced immediately.
1. Before starting work, the correct operation of all handling and safety devices must be
checked.
Read the user's manual.
2.
3. Release the trigger on the motor switch if the trigger has been set.
4. Check all the bolts and connections are well tighten.
5. Check the battery charge status.
6. Turn on the motor. Sometimes, if the battery is fully charged, it is necessary to operate the
switch 2-3 times in a row. This is due to the battery has an overcharge protection system that
sometimes kicks in when the battery is fully charged.
7. Carry out the work holding the vibrator by the handle of the bar and with the belt placed
across the user's shoulder.
8. After the work is finished, clean with water the remains of fresh concrete adhering to the
vibrator poker.
9. When a defect or a malfunction has been detected, endangering the use of this machine or
not, stop the work and make the correspondent maintenance to avoid any danger or bigger
damage.
1. Before working, make sure the transmission to the motor is tight (tighten by turning
counterclockwise by hand).
2. Make sure the poker is tightly screwed into the transmission before working (hold left hand
threading with wrench).
3. When the poker does not generate vibration while the engine is running, give a light blow to
the tip.
4. Do not operate the transmission with sharp bends.
5. Do not over grease the flexible shaft.
6. Do not hold the poker running out of the concrete for more than 5 minutes.
7. Do not limit the movement of the vibrator during work.
8. Do not stop the poker during the vibrating operation.
9. Replace worn tubes and tips to avoid damage to internal components.