Operation And Maintenance; Starting Procedure - Enarco TIFON Serie Manuel D'instructions

OPERATION AND MAINTENANCE

4

STARTING PROCEDURE

Electric models:
Insert the plug into its place.
Put the safety/stop switch on "ON" position.
TIFÓN 600 E: Just turn the switch to position "1".
TIFÓN 900 E: Turn the switch to position "1". If the machine does not start and just makes noise,
that shows you selected the wrong direction of rotation. Stop the machine and turn the switch to
position "1" on the opposite side. To increase the rotation speed of the blades turn the switch to
position "2".
Petrol models:
Be sure the fuel tank is full. Use the recommended gasoline to run the engine from its instruction
book.
Check the engine oil levels.
Turn the engine stop switch to the position "ON".
Open the fuel cock.
Set the speed control lever 1/3 of the way towards the high-speed position.
If the engine is warm or the ambient temperature is high, close the choke lever half way, or keep it
open fully. If the engine is cold, or the ambient temperature is low, close the choke lever.
Pull the starter handle slowly until the resistance is felt. Return the handle to its original position
and pull swiftly.
en Allow a longer warm-up period in cold weather temperatures.
OPERATION
Get into the operator's position behind the centre of the handle. Attain a good feet position and start
the machine. (A)
Push handle down to move the machine right (B), lift handle up to move the machine left gently.
(C)
The machine will remain stationary, it you do not apply any force up and/or down.
8
TROWELS WITH ELECTRIC OR PETROL ENGINE