Operating The Machine - Enarco TEN2540 Manuel D'instructions

OPERATING THE MACHINE

It moves on the skew
It does not advance
Moves back very slowly
Moves forward very slowly
Hydraulic oil leaks
REVERSIBLE PLATE COMPACTORS
TEN2540-TEN2550-TEN3040-TEN3050
•
Insufficient engine capacity
•
The clutch is slipping
•
The V-belt is slipping
•
Too much vibrating oil
•
Internal parts of the vibrator are faulty
•
V-belt uncoupled or slipping
•
The clutch is slipping
•
Mechanical fault in the cam box: contact technical department (SAT) at
Enarco.
•
It vibrates but does not move. The vibrator may be on a slippery, wet
surface. Try on the right surface.
•
Lack of oil in the hydraulic control unit for the compactor: top up with oil
following the instructions given in point 7.13.
•
Air in the hydraulic control circuit: purge the circuit.
•
Too much oil in the hydraulic control unit: remove oil from the circuit
until it reaches the control level.
•
Loss of oil-tightness, flaws in hydraulic hose: replace the faulty
components.
en
29