Installing Or Removing A Blade - Evolution STEALTH 3-B Instructions Originales

www.evolutionpowertools.com
(8.10)
SUPPORTNG LONG WORKPIECES
The free end of a long workpiece should be supported at the
same height as the machine table. The operator should consider
using a remote workpiece support if thought necessary.
(8.11)

INSTALLING OR REMOVING A BLADE

WARNING: Only carry out this operation with the machine
disconnected from the mains supply.
WARNING: Only use genuine Evolution blades which are
designed for this machine. Ensure that the maximum speed
of the blade is higher than the speed of the motor.
Note: It is recommended that the operator considers wearing
protective gloves when handling the blade during installation
or when changing the blade.
• Ensure the Cutting Head is in its upper position.
• Remove the lower guard operating arm from the machine by
removing the pivot screw. (Fig. 24) Store this screw safely for
future use.
• Press the lower blade guard locking lever (a) and rotate
the lower blade guard (b) up and into the upper blade
guard. (Fig. 25)
• Press the black arbor lock button to lock the arbor. (Fig. 26)
Fig. 24
Fig. 25
Fig. 26
25
EN
DE
FR
IT
NL