Maintenance - Evolution EVOSAW185 Instructions D'origine

www.evolutionpowertools.com
• Only remove your hands, or the workpiece from the
machine, after the motor has completely stopped and the
stationary blade is covered by the lower blade guards.

MAINTENANCE

Note: Any maintenance must be carried out with the machine
switched off and disconnected from the mains/battery
power supply.
Check that all safety features and guards are operating
correctly on a regular basis. Only use this machine if all guards/
safety features are fully operational.
All motor bearings in this machine are lubricated for life.
No further lubrication is required.
Use a clean, slightly damp cloth to clean the plastic parts of the
machine. Do not use solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by inserting pointed
objects through openings in the machine's casings etc. The
machine's air vents should be cleaned using compressed dry air.
Note: Excessive sparking may indicate the presence of dirt in
the motor or worn out carbon brushes.
CHECKING/REPLACING THE CARBON BRUSHES
WARNING: Disconnect the machine from the power supply
before attempting to check or replace the Carbon Brushes.
Replace both carbon brushes if either has less than 6mm
length of carbon remaining, or if the spring or wire is damaged
or burned.
TO REMOVE THE BRUSHES:
• Unscrew the plastic caps found at the back of the motor.
Be careful as the caps are spring-loaded.
• Withdraw the brushes with their springs.
• If replacement is necessary, exchange the brushes and
replace the caps.
Note: Used but serviceable brushes can be replaced, but only
as long as they are returned to the same position, and inserted
the same way round, as they were removed from the machine.
• Run new brushes without load for approximately 5 minutes.
This will help the bedding-in process.
17
EN