Evolution STEALTH 3-B Instructions Originales page 18

Fig. 7
Fig. 8
Fig. 9
BEVEL ANGLES (0 AND 45
0
0 Bevel Stop Adjustment
0
• Ensure that the Cutting Head is in the locked down position
with the latching pin fully engaged in its socket. (see Fig.15)
• Ensure that the Cutting Head is upright, against its stop and
the bevel pointer is indicating 0
• Place the Set Square on the table with one short edge
against the table and the other short edge against the blade
(avoiding the TCT tips). (Fig. 8)
• If the blade is blade is not 90
adjustment is required.
• Loosen the Bevel Lock Handle and tilt the Cutting Head
to the left.
• Loosen the locknut on the Bevel Angle
Adjustment Screw. (Fig. 9)
• Use a Hex Key to turn the screw in or out
to adjust the blade angle.
• Return the Cutting Head to its upright position and recheck
the angular alignment against the Set Square.
• Repeat the above steps until correct angular
alignment is achieved.
• Tighten the Bevel Angle Adjustment locknut securely.
18
www.evolutionpowertools.com
)
0
on the scale. (Fig. 7)
0
square with the mitre table
0