Evolution STEALTH 3-B Instructions Originales page 19

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

www.evolutionpowertools.com
0
Bevel Pointer Adjustment
0
NOTE: The operator must be satisfied that the blade is set
exactly perpendicular to the table when in the upright position
and against its stop.
• If the pointer is not in exact alignment with the 0
the protractor scale adjustment is necessary.
• Loosen the Bevel Pointer screw using a #2 Phillips
screwdriver. (Fig. 10)
• Adjust the Bevel Pointer so that it is in alignment exactly with
the 0
mark.
0
• Retighten the screw.
45
Bevel Stop Adjustment
0
• Loosen the Bevel Lock Handle and tilt the Cutting Head
completely to the left until it rests against the 45
• Use a Set Square to see if the blade is at 45
(avoiding the TCT tips).
• If the saw blade is not in exact alignment adjustment
is necessary.
• Return the Cutting Head to its upright position.
• Loosen the locknut on the 45
• Use a Hex Key to adjust the Adjustment Screw in or out
as required. (Fig. 11)
• Tilt the Cutting Head to the 45
alignment with the Set Square.
• Repeat the above steps until the correct angular alignment
is achieved.
• Tighten the Adjustment Screw locknut securely once
alignment is achieved.
Fence Alignment
The fence must be aligned at 90
blade The rotary table must be set at '0
The Fence is fastened to the table with two socket head Hex
screws positioned at either side of the fence in elongated slots.
(Fig. 12)
mark on
0
stop.
0
to the table
0
Bevel Adjustment Screw.
0
setting and recheck for
0
(square) to a correctly installed
0
' miter angle.
0
19
Fig. 10
Fig. 11
Fig. 12
EN
DE
FR
IT
NL

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fury3-bFury3b2102Fury3b2102euStealth3b2102Stealth3b2102eu

Table des Matières