Compound Cutting; Cutting Bowed Material; Clearing Jammed Material - Evolution STEALTH 3-B Instructions Originales

Fig. 22
Fig. 23
When cutting is completed:
• Release the ON/OFF trigger switch, but keep your hands
in position and allow the blade to completely stop.
• Allow the Cutting Head has to rise to its upper position, with
the lower blade guard completely deployed before removing
yours hand(s).
• Return the Cutting Head to the perpendicular position.
• Tighten the bevel lock lever.
(8.7)

COMPOUND CUTTING

A compound cut is a combination of a mitre
and bevel cut employed simultaneously.
When a compound cut is required, select the desired
bevel and mitre positions as previously described.
Always check that the path of the blade does not interfere
with the machines fence or any other parts of the machine.
Adjust the upper left hand section of the fence if necessary.
(8.8)

CUTTING BOWED MATERIAL

Before cutting any workpiece, check to see if it is bowed.
If it is bowed the workpiece must be positioned
and cut as shown.
Do not position the workpiece incorrectly or
cut the workpiece without the support of the fence.
(8.9)

CLEARING JAMMED MATERIAL

• Turn mitre saw "OFF" by releasing the trigger switch.
• Allow the blade to come to a complete halt.
• Unplug the mitre saw from the mains supply.
• Carefully remove any jammed material from the machine.
• Check the condition and operation of the safety guard.
• Check for any other damage to any part of the
machine e.g. the blade.
• Have any damaged parts replaced by a competent
technician and a safety inspection carried out before
using the machine again.
24
www.evolutionpowertools.com
(Fig. 22)
(Fig. 23)