Evolution STEALTH 3-B Instructions Originales page 20

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Fig. 13
Fig. 14
• Ensure that the Cutting Head is in the locked down position
with the latching pin fully engaged in its socket.
• Place a Set Square on the table with one short edge against
the Fence and the other short edge against the Blade
(avoiding the TCT tips). (Fig. 13)
• If adjustment is necessary, loosen the four Fence adjustment
screws using a Hex Key.
• Re-position the Fence in its elongated slots until
alignment is achieved.
• Securely tighten the socket head Hex screws.
Mitre Angle Pointer Adjustment
NOTE: There are dual miter angle scales cast into the front of
the machines base. A small pointer attached to the rotary table
indicates the angle selected.
If necessary the pointer can be repositioned by loosening
its fastening screw using a #2 Phillips screwdriver. Adjust as
necessary, and then securely tighten the fixing screw. (Fig. 14)
FINAL ADJUSTMENT CHECKS
With the machine switched OFF and disconnected
from the mains supply carry out the following;
When all adjustments have been made, set the
machine at each of the maximum settings.
Lower the blade to its lowest position and rotate the blade
by hand, (it is advisable to wear gloves whilst doing this),
and ensure that the blade does not foul on any part
of the machine castings or guards.
20
www.evolutionpowertools.com

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fury3-bFury3b2102Fury3b2102euStealth3b2102Stealth3b2102eu

Table des Matières