Pan Detection; Residual Heat Indication; Power Management; Booster Function - BORETTI M-system MI-90 Notice D'emploi

Pan detection

The pan detection ensures a perfect safety. The induction doesn't work :
• If there is no pan on the heating zone or if this pan is not adapted to the induction. In this case
it is impossible to increase the power and the display shows [ U ]. This symbol disappears when
a pan is put on the heating zone.
• If the pan is removed from the heating zone the operation is stopped. The display shows [ U ].
The symbol [ U ] disappears when the pan is put back to the heating zone. The cooking continues
with the power level setted before.
After use, switch the heat element to off: don't let the pan detection [ U ] active.

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display. The symbol [ H ] disapears when the heating zones may be
touched without danger. As far as the residual heat indicators are on light, don't touch the heating
zones and don't put any heat sensitive object on them . There are risks of burn and fire.

Power management

The hole cooking hob is equipped by a maximum of power. When the booster function is activated,
and not to exceed the maximum power, the electronic system orders to reduce automatically the
power level of one or several heating zones. Displays is blinking on [ 9 ] during a few seconds and
then shows the maximum of power allowed ( [ 6 ] or [ 8 ] ).
Heating zone selected
[ P ] is displayed

Booster function

The first booster function [ P ] and the second booster [
selected heating zone.
If this function is activated the heating zones work during 10 minutes with an ultra high power.
Power is foreseen for example to heat up rapidly big quantities of water, like nuddles
• Start up / Stop the First booster
Action
Start up booster
Zone selection
Stop booster
The other heating zone:(example: power level 9)
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Control panel
Press [ P ] key
Press key [ + ] or [ - ] from the desired
heating zone
Press key [ - ] from the boosted
heating zone
] grants a boost of power to the
Display
control light is on
[ P ]
[ 9 ]
NL
FR
D
EN
57