Pan Detection; Residual Heat Indication; Booster Function - BORETTI BIKW-76 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Pan detection

The pan detection ensures a perfect safety. The induction doesn't work:
• If there is no pan on the heating zone or if this pan is not adapted to the induction. In this case
it is impossible to increase the power and the display shows [ U ]. This symbol disappears when
a pan is put on the heating zone.
• If the pan is removed from the heating zone the operation is stopped. The display shows [ U ].
The symbol [ U ] disappears when the pan is put back to the heating zone. The cooking continues
with the power level set before.
After use, switch the heat element off : don't let the pan detection [ U ] active.

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.

Booster function

The booster function [ P ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones work during 10 minutes with an ultra high power.
The booster is foreseen for example to heat up rapidly big quantities of water, like nuddles cooking.
• Start up / Stop the booster function:
Action
Zone selection
Start up the booster
Stop the booster
• Power management:
The hole cooking hob is equipped by a maximum of power. When the booster function is activated,
and not to exceed the maximum power, the electronic system orders to reduce automatically the
power level of an other heating zone. The display is blinking on [ 9 ] during a few seconds and then
shows the maximum of power allowed :
Heating zone selected
[ P ] is displayed
Control panel
press key [ 0 ] from the zone
press key [ P ]
slide on the "SLIDER"
or press on [ P ]
The other heating zone: (example: power level 9)
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Display
[ 0 ] and control light on
[ P ]
[ P ] to [ 0 ]
[ 9 ]
NL
FR
D
EN
59

Publicité

Chapitres

Table des Matières
loading

Table des Matières